PSU Sample Paper 4
PSU Sample Paper 4 – mcqs in electrical engineering, mcqs in electronics and comunication, power consumption, psu sample papers for cs, psu question papers

A digitaltoanalog converter with a fullscale output voltage of 3.5 V has a resolution close to 14m V. Its bit size is
A) 4B) 8C) 16 D) 32
Answer : (B) 
A singlephase halfcontrolled rectifier is driving a separately excited dc motor. The dc motor has a back emf constant of 0.5 V/rpm. The armature current is 5 A without any ripple. The armature resistance is 2W. The converter is working from a 280 V, single phase ac source with a firing angle of 80°. Under this operating condition, the speed of the motor will be A) 339 rpm B) 359 rpm C) 366 rpm D) 386 rpm
Answer : (C) 
3 In relation to the synchronous machines, which one of the following statements is false? A) In salient pole machines, the directaxis synchronous reactance is greater than the quadratureaxis synchronous reactance B) The damper bars help the synchronous motor self start
C) Short circuit ratio is the ratio of the field current required to produce the rated voltage on open circuit to the rated armature current
D) The Vcurve of a synchronous motor represents the variation in the armature current with field excitation, at a given output power  Answer : (C)

A parallel plate airfilled capacitor has plate area of l04 m2 and plate separation of 103 m. It is connected to a 0.5 V, 3.6 GHz source. The magnitude of the displacement current is (e0 = 1/36p x 109 F/m) A) 10 mAB) 100 mAC) 10 A D) 1.59 mA
Answer : (A) 
The 8085 assembly language instruction that stores the content of H and L registers into the memory locations 2050H and 2051H, respectively, is
A) SPHL 2050H B) SPHL2051H C) SHLD 2050H D) STAX 2050H
Answer : (C) 
If E is the electric field intensity, Ñ(Ñ x E ) is equal to A) E B) E C) null vector D) zeroAnswer : (D) 7 The insulation strength of an EHV transmission line is mainly governed by
A) Load power factor B) switching overvoltages C) harmonics D) corona
Answer : (B) 
The Q – meter works on the principle ofA) mutual inductanceB) self inductanceC) series resonance D) parallel resonance
Answer : (C) 
A 800 kV transmission line is having per phase line inductance of 1.1 mH/km and per phase line capacitance of 11.68 nF/km. Ignoring the length of the line, its ideal power transfer capability in MW isA) 1204 MWB) 1504 MWC) 2085 MW D) 2606 MW
Answer : (C) 
In a PCM system, if the code word length is increased from 6 to 8 bits, the signal to quantization noise ratio improves by the factor A) 8/6B) 12C) 16D) 8
Answer : (C) 
At an industrial substation with a 4 MW load, a capacitor of 2 MVAR is installed to maintain the load power factor at 0.97 lagging. If the capacitor goes out of serivce, the load power factor becomes A) 0.85 B) 1.00 C) 0.80 lag D) 0.90 lag Answer : (C)
The conduction loss versus device current characteristic of a power MOSFET is best approximated by A) a parabola B) a straight lineC) a rectangular hyperbolaD) an exponentially decaying function
Answer : (A) 
High Voltage DC (HVDC) transmission is mainly used for A) bulk power transmission over very long distancesB) interconnecting two systems with the same nominal frequencyC) eliminating reactive power requirement in the operationD) minimizing harmonics at the converter stations
Answer : (A) 
For the equation,s3 – 4s2+ s + 6 = 0the number of roots in the left half of splane will beA) 0B) 1C) 2D) 3
Answer : (C) 
For the function f(x) = x2 ex, the maximum occurs when x is equal to A) 2 B) 1C) 0D) 1
Answer : (B)
If you are going for most excellent contents like I do,
just go to see this site everyday as it offers quality contents,
thanks